Hitec HSB-9380TH Ultra Torque Brushless Titanium Gear Servo (High Voltage)

Description

The Hitec HSB-9380TH Ultra Torque Brushless Titanium Gear Servo features an ultra-efficient brushless motor, titanium gears, low current consumption and constant output power. This makes the HSB-93XX series of servos a great choice for discriminating pilots and racers.
NOTE:
While compatible with most radio control devices, the regenerative braking feature of the HSB-9XXX series servos may cause a problem if the device cannot accept a backflow of current. The types of devices that cannot accept this backflow are: Voltage Regulators, Power Safe Receivers and certain BEC circuits whether stand alone or integrated within an Electronic Speed Control. Check with the manufacturer or the Hitec website for a list of compatible models. If your device cannot accept a current backflow, then you must install a PAD (Power Absorbing Device - HRC55756) as described in the manual. A PAD is included with every Hitec brushless servo.
Features:
Programmable 12-Bit PWM Digital Amplifier
Custom Long Life Brushless Motor
1M Cycle Long Life Potentiometer
Constant Output Torque
Wide Operating Voltage (5 ~ 9 Volts DC)
Dual Ball Bearing Supported Output Shaft
Dust Resistant and Splash Proof Case
25-Tooth Output Spline
Hybrid Nylon Reinforced Plastic and Aluminum Case
Low Power Consumption
Programmable Functions:
End Point Adjustments
Direction
Fail Safe
Dead Band
Speed (Slower)
Soft Start Rate
Data Save / Load
Program Reset (From File)
Specifications:
Performance:
Operating Voltage Range (Volts DC):
6.0V ~ 7.4V
Speed (Second @ 60°):
0.17 ~ 0.14
Maximum Torque Range oz. / in.:
472
Maximum Torque Range kg. / cm.:
34
Current Draw at Idle:
27 mA
No Load Operating Current Draw:
250 mA
Stall Current Draw:
2,100 mA
Dead Band Width:
1 µs
Physical Specifications:
Dimensions (Inches):
1.57 x 0.79 x 1.50
Dimensions (Metric):
40.0 x 20.0 x 38.0
Weight (Ounces):
2.4
Weight (Gram):
68.0
Circuit Type:
EBL Digital
Motor Type:
Brushless
Gear Material:
Titanium
Bearing Type:
Dual Ball Bearing
Output Shaft (type / Ømm):
H25T
Case Material:
Plastic / Aluminum
Dust / Water Resistance:
Splash Proof
Connector Gauge (AWG) / Strand Count:
20 / 80
Applications:
Parkflyer:
N / A
Sport Plane:
> 40%
Sailplane:
2 meters and up
3D Performance:
> 40%
Scale:
> 40%
Electric Helicopter:
N / A
Gas Helicopter:
N / A
On Road:
N / A
Monster Truck:
1/8th
Buggies:
1/8th
Truggies:
1/8th
Short Course / Truck:
1/8th
Crawlers:
N / A
Sail Boat:
= >1M & Scale
Power Boat:
1/10th
About Us
|
View Store