Servo Mounting Screws Plus Extra Long Bondhus Ball Driver Set for all RC Hobbies

Description

These are "Super Long" Premium Ball Drivers!
Please
visit our
eBay store
Servo Mounting Screw Assortment #5745
(included with your order)
Great kit to have at the field and in the workshop. You will reach for it many times whenever you need a small pointy screw with a washer attached. Many more uses than just Servo Mounting!
This assortment contains the following:
One hundred pieces each of Socket Head/Washer Head Screws: 2x5/16, 2x7/16, 2x9/16
and 50 pieces each of: 3x7/16, 3x5/8).
All the screws take a standard 5/64" Hex (allen wrench) or balldriver.
We have also included 50 pieces each of our #2 and #4 Nylon Washers.
(The #4 washers work well with the #3 screws) These washers are very good for cushioning the pressure on plastic and fiberglass cowls, canopies, etc. Also spreads the load over a slightly larger surface and helps reduce damage to these parts. Outside diameter of these washers is 1/4"
Total pieces = 500
Plus
Set of 8 Bondhus Extra Long Ball Drivers with ProGuard Finish .050" to 3/16".
10.5" to 11" blades.
Includes sizes .050, 1/16, 5/64, 3/32, 7/64, 9/64, 5/32, and 3/16 inch. This is a c
ustomized set to fit popular socket drive screws. There is a picture (chart) above that you can enlarge and see the exact size fasteners that this set can handle. You can print the chart. This set will handle mostly all RTL Fasteners hardware.  You can see on eBay that the price of each extra long ball driver is quite high (and I have never seen them offered as sets.)
No screw will be out of reach! Here's my personal true story that many folks will relate to: "For many years I didn't have these long ball drivers. I remember how many times I wish I did. I recall losing an airplane because I was too lazy to take the cowl off to check the tightness of the engine mounting bolts. I remember taking the spinner off and seeing that I could actually get to the engine mounting bolts at about a 10 degree angle but they were about seven or eight inches in, and there was no way any ball driver that I had would reach that far. Well long story short, the engine mounting bolts were loose and I lost the plane. Bam ,000.00 gone!"
Rich, RTL Fasteners..."30 years in the hobby and still learning.....sometimes the hard way!"